Feedthrough power determination in a two-mode waveguide with galvanomagnetic transducers
DOI:
https://doi.org/10.1109/ICATT.2003.1238865Keywords:
galvanomagnetic transducer, two-mode waveguide, feedthroughAbstract
Peculiarities of the application of galvanomagnetic transducers for feedthrough power measurement in a two-mode waveguide are considered. There is indicated a necessary amount of transducers as well as their position coordinates and a method of their connection for feedthrough power measurement both as a total electromagnetic field and selectively with respect to wave modes. The results of experimental investigation have been stated.References
Geyvandov, L.N. Highway method of EME forecasting, which determines EMC of RES at SEF. Works of III Republican Sci. Tech. Conf. on Measurement methods and means in the field of electromagnetic compatibility, Vinnitsa, Ukraine, 1991, pp. 23-27.
Forrer, M.P.; Tomiyasu, K. Determination of higher orders propagating modes in wave-guide systems. Journal of Applied Physics, 1958, Vol. 29, No. 7, p. 1040-1046.
Badalov, F.L.; Mikhailov, A.S. Norms for parameters of electromagnetic compatibilityof RES: Reference book. M.: Radio and Communication, 1990.
Vuntesmeri, V.S.; Ivkin, P.V. Use of galvanomagnetic sensors for feedthrough power measurement in a multiwave waveguide. Naukovi Visti of the National Technical University of Ukraine “KPI”, 2001, No. 2, p. 12-16.
Ivkin, P.V. Application of galvanomagnetic sensors for power flow measurement in a two-mode waveguide. Izvestiya Vuzov. Radioelektronika, 2001, Vol. 44, No. 6, p. 64-69.
Geyvandov, L.N.; Kurkov, O.S. Automated measurement and calculation complex on the basis o the probe method of the mode analysis of the waveguide highway field. Works of III Republican Sci. Tech. Conf. on Measure methods and means in the field of electromagnetic compatibility, Vinnitsa, Ukraine, 1991, pp. 134-137.
