Built-in performance monitoring system for active phased-array antennas
DOI:
https://doi.org/10.1109/ICATT.2007.4425252Keywords:
active phased-array antenna, antenna measurements, automatic fault diagnostics, calibration, initial alignment, performance monitoringAbstract
In active phased array antennas, transmit and receive functions are distributed at the aperture using transmit and receive (T/R) modules. Active phased arrays are typically calibrated in a near-field antenna range at the factory. The performance of active phased array antennas would degrade over time due to changes in the characteristics of active devices and would require recalibration in the field. The conditions and methods required for the active phased-array antenna (APAA) measurements, initial alignment, further automatic diagnostics and performance monitoring are described. Special attention is paid to constructive peculiarities of APAA and measurement restrictions. A numerical model of performance monitoring process has been developed and many test cases examined in an effort to isolate and characterize errors commonly found in the built-in performance-monitoring systems (BPMS). Both simulation and measurement results are presented to demonstrate the utility of the proposed measurement and monitoring techniques. Future research directions in applying BPMS are highlighted.References
PASCHEN, D.; MOOSBRUGGER, P.; MEENACH, T. Active and Adaptive Antenna Testing. Proc. of Antenna Measurement Techniques Association, 2001, (2001-02-02 - A105), p.43-47.
COUPER, P.; THOMPSON, K.; DAVIS, R.; BARNES, T. Active Array High-Power Superposition Near-Field Measurement Technique: Results, Analysis, and Practical Considerations. Proc. of Antenna Measurement Techniques Association, 2000, p.198-203.
LEE, K.; CHU, R.; LIU, S. A built-in performance-monitoring/fault isolation and correction (PM/FIC) system for active phased-array antennas. IEEE Trans. Antennas Propag., Nov. 1993, v.41, n.11, p.1530-1540.
MARKOV, V.; KOZLOV, A. Built-in Performance Monitoring Systems for Phased-Array Antennas with Binary Phase Shifters. Proc. of Antenna Measurement Techniques Association, AMTA'03, Irvine, California, 2003, p.560-567.
AGRAWAL, A.; JABLON, A. A calibration technique for active phased array antennas. Proc. of IEEE Int. Symp. on Phased Array Systems and Technology, 14-17 Oct. 2003. 2003, p.223-228.
GAO, TIE; GUO, YANCHANG; WANG, JINYUAN; CHEN, XUELI. Large active phased array antenna calibration using MCM. Proc. of IEEE Antennas Propagation Society Int. Symp., 8-13 July 2001, Boston, MA, USA. IEEE, 2001. v.2, p.606-609, doi: http://dx.doi.org/10.1109/APS.2001.959796.
KAVALEROV, D.; MARKOV, V. Effektivnyi algoritm otsenki parametrov elementov antennykh reshetok moduljatsionnym metodom. Proc. of VKAI-3 on Metrologicheskoe Obespechenie Antennykh Izmereniy, Erevan, 1984, p.396-398.
USIN, V.A.; MARKOV, V.I.; ROZNJATOVSKAJA, L.V. Analysis of the electromagnetic field structure illuminating the aperture of phased-array antennas from far field distance. Proc. of 15th Int. Crimean Conf. Microwave & Telecommunication Technology, 12-16 Oct. 2005. IEEE, 2005, v.1, p.360-361, doi: http://dx.doi.org/10.1109/CRMICO.2005.1564941.
MAILLOUX, R. Array failure correction with a digitally beamformed array. IEEE Trans. Antennas Propag., Dec. 1996, v.44, n.12, p.1543-1550, doi: http://dx.doi.org/10.1109/8.546240.
LEVITAS, M.; HORTON, D.; CHESTON, T. Practical failure compensation in active phased arrays. IEEE Trans. Antennas Propag., Mar. 1999, v.47, n.3, p.524-535, doi: http://dx.doi.org/10.1109/8.768788.
